Before you start:
1. Read the instructions carefully.
2. Work over a sink or a surface covered in layers of newspaper (just in case).
3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out
cartridges. Even 30 minutes can ruin a cartridge if it dries out!
4. Have your printer manual handy for instructions on inserting a “new” cartridge.
Black Cartridges
 1. Using the Thumb Drill included enlarge the filling hole on the top of the cartridge.
(Do not remove the cap).
2. Fill the syringe with ink, insert the filling needle into the filling hole and push as far down
into the cartridge as it will go. Inject approximately 15cc. of ink SLOWLY, or until the reservoir
is full.
3. Set above a paper towel for half an hour as a drip precaution. Expect a few drips. Do not allow
the cartridge to touch the paper towel at this point, since the towel will draw out the ink.
4. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
IMPORTANT – For
best results, cartridge should be refilled whilst some ink remains.
Empty cartridges should be refilled immediately.
This work is best done over the sink.
|
