Before you
start:
1. Read the
instructions carefully.
2. Work over
a sink or a surface covered in layers of newspaper (just in
case).
3. Only re-fill
a cartridge that has just run out ~ this kit will not work
with old dried out cartridges. Even 30 minutes can ruin a cartridge if it dries out!
4. Have your
printer manual handy for instructions on inserting a “new” cartridge.
 1. Put the Ink Cartridge on some paper towels or Newspaper in an area where you can tolerate a
spill.
2. Peal off the top label.
3. Follow the canal trace from the edge of the label to the very small hole at the end of the canal.
This hole is big enough for a human hair to go through but not a syringe needle.
4. Drill all three holes (Cyan, Magenta, and Yellow) larger with the thumb drill provided.
5. Fill the syringe with 7 ml. of the CORRECT colour ink.
6. Very CAREFULLY inject ink into each chamber until the sponge is full. A little ink might come
out of the top when full, so cover up the other two holes while filling one.
7. When finished, replace the top label with some adhesive tape.
8. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
If necessary leave cartridge in printer for up to 8 hours.
** NOTE** The cartridge will print just like a new one. Even though the cartridge prints fine,
the ink level gauge will not read full after a refill.
|
