Before you start:
1. Read the instructions carefully.
2. Work over a sink or a surface covered in layers of newspaper (just in case).
3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out cartridges.
Even 30 minutes can ruin a cartridge if it dries out!
4. Have your printer manual handy for instructions on inserting a “new” cartridge.
1. Put the cartridge on some paper towels in an area where you can tolerate a spill.
2. Remove the identification label from the top of the cartridge.
3. Insert the needle into the appropriate filling hole and push halfway into the cartridge. Please
ensure you are injecting the correct colour into the correct hole. It doesn’t matter on the
black but it does with the colour cartridge.
4. Slowly inject the ink. If ink appears at the filling hole, gently pull back on the plunger to
remove the excess ink. Blot the printhead with absorbent material until it stops dripping before
moving onto the next colour.
5. Do not replace the identification label.
6. Ensure the printhead has stopped dripping before returning the cartridge to the printer. Replace
the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
7. Clean the syringe & needle thoroughly for future use. If necessary leave newly filled cartridge in printer for up to 24 hours before using.
IMPORTANT: Even though the cartridge prints just fine, the ink level gauge will NOT read full after
a refill.
IMPORTANT: For best results, cartridge should be refilled whilst some ink remains
Empty cartridges should be refilled immediately.
This work is best done over the sink
|
