Before you start:
1. Read the instructions carefully.
2. Work over a sink or a surface covered in layers of newspaper (just in case).
3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out
cartridges. Even 30 minutes can ruin a cartridge if it dries out!
4. Have your printer manual handy for instructions on inserting a “new” cartridge.
 1. Carefully remove the top of the BC-21/24 cartridges using a penknife or Stanley knife (the
top is the smaller section positioned on top of the cartridge)
2. Enlarge the filling hole(s) in the top of the cartridge sufficiently to accept the steel filling
tube using the screw provided.
3. Insert the steel filling tube into the appropriate filling hole and push into the centre of
the cartridge.
IMPORTANT – The cartridge contains a sponge and slight resistance may be felt.
4. SLOWLY inject ink into cartridge. When ink overflows from filling hole or starts to leak from
outlet hole, cartridge is full. DO NOT seal filling holes.
5. Replace the top and secure with adhesive tape (BCJ-21)
6. Unused ink may be returned to the bottle. Leave cartridge to stand overnight on a protective,
nonabsorbent surface.
IMPORTANT – For best results, cartridge should be refilled whilst some ink remains.
Empty cartridges should be refilled immediately.
This work is best done over the sink.
|
