Before you start:
1. Read the instructions carefully.
2. Work over a sink or a surface covered in layers of newspaper (just in case).
3. Only re-fill a cartridge that has just run out ~ this kit will not work with old dried out cartridges.
Even 30 minutes can ruin a cartridge if it dries out!
4. Have your printer manual handy for instructions on inserting a “new” cartridge.
 1. Using the tools provided, pry out the small white plug located next to the outlet hole. It
is not necessary to remove the entire plug from the outlet hole.
2. Attach the needle to the syringe and fill with the appropriate colour of ink for the cartridge
you are filling.
3. Insert the syringe into the small hole underneath the white plug.
4. SLOWLY inject 6-8ml of ink into the cartridge until ink starts to surface. Note: You can see
the ink level through the translucent back of the cartridge. Any unused ink may be returned to
the bottle.
5. Reinsert the plug back into position making sure that the small nipple on the bottom of the
plug is reseated into the small filling hole of the cartridge.
6. Thoroughly rinse the syringe with water and dry between colours or to store for future use.
7. Install the cartridge and run a priming cycle as per printer instructions.
IMPORTANT – for best results, cartridge should be refilled whilst some ink remains
Empty cartridges should be refilled immediately.
This work is best done over the sink.
|
